The Jaltest MDC10 is a diagnostic cable specifically designed for testing brake wear sensors (BWS) from Knorr-Bremse on commercial vehicles. This cable forms the connection between a 3-pin BWS connector on the vehicle side and the Jaltest ETM (Electronic Test Module). It enables a technician to perform a direct and isolated diagnosis on the sensor, contributing to an accurate analysis of the braking system.

The functionality of the MDC10 cable is focused on performing component-specific tests with the Jaltest ETM module. This allows verification of the correct operation and signal output of the Knorr-Bremse brake wear sensor, independent of the vehicle's electronic control unit (ECU). By testing the sensor in isolation, faults can be efficiently located and the sensor's condition objectively determined.

Application and functionality:

This cable is intended for connecting the Jaltest ETM module with Knorr-Bremse brake wear sensors for diagnostic and testing purposes.

• Direct sensor diagnosis: Enables a direct connection to the Knorr-Bremse Brake Wear Sensor (BWS) for targeted tests.
• Component testing: Allows the user to check the sensor independently from the vehicle system for correct operation.
• Signal verification: Suitable for measuring and validating the signals emitted by the brake wear sensor.

Compatible vehicles and applications:

This diagnostic cable is developed for use on commercial vehicles such as trucks, trailers, and buses equipped with a Knorr-Bremse braking system and a compatible 3-pin brake wear sensor (BWS). Such systems are used by various manufacturers, including:

• DAF
• Iveco
• MAN
• Mercedes-Benz
• Renault Trucks
• Scania
• Volvo Trucks

Important: The application depends on the installed braking system and the specific sensor. Always check the connection on the vehicle before purchasing the product, as it may vary by model and year of manufacture.

Package Contents:

• 1x Jaltest (MDC10) | Knorr-Bremse 3-pin BWS Diagnostic Cable

Technical specifications: