Complete Shaft

Over-run Clutch Yoke
Designed to allow high RPM implements to wind down when the tractor PTO is disengaged, protecting the drive shaft and tractor from damage, caused by the transmission of inertial loads from the implement.

Quick-Release Coupler
For both tractor and implement ends. To fit standard 1 3/8" x 6 spline drive shafts. Totally secure, yet quick & easy to hitch/unhitch.

Telescopic "Bell" Shaft
With a minimum end-to-end distance of 1350mm, extends to suit distance required for implement. "Bell" tube profile for moderate to heavy loads.

Fully Shielded
Shaft is complete with a FULL Safety Shield. Do not operate the driveline if shielding is not in place. Shaft Guard must turn freely on the driveline.

IMPORTANT
Refer to User Manual for instructions on greasing, shortening and general use.

Technical specification

• Tube Type: Tri-Wall/Bell
• Outer Tube Thickness: 43.4mm
• Outer Tube Wall Thickness: 3.3mm
• Inner Tube Thickness: 36.1mm
• Inner Tube Wall Thickness: 4.4mm
• Closed Length: 1200mm
• PTO Stub Fitment: 1 3/8" x 6 Spline