1cup = approx. 50ml of espresso coffee

Features:      
•100% brand new

•Quick boilling,just need 3-4 minutes

•PC and aluminum material,the handle and base use Nylon material

•Power indicater light and Auto shut-off after 30 minutes.

•Cordless and detachable from the base.

•360 degree rotation.

•Product size:18*13.5*24.2cm 

         HOW TO PREPARE THE COFFEE:    
1) Check   that the coffee maker is cold, and then unscrew it by holding the   boiler with one hand and turning the pitcher anticlockwise with the   other (Fig.1).
2) Remove   the funnel and , to prepare 3 cups of coffee, fill the boiler with   fresh water until reaching the safety valve ( visible inside the   boiler),without exceeding it (Fig.2). On the other hand, to prepare 3  cups, fill the boiler with water to the mark ( at round 2 centimeters)   below the safety valve.        TIP: use fresh and soft water. Salty or hard water will weaken the flower.        IMPORTANT: do not use the coffee maker without water in the boiler or alternatively using hot water for faster operation .
3) Insert   the funnel filter in the boiler ( Fig. 3). To prepare six cups of   coffee, also insert the 3 cup adapter in the funnel filter( Fig. 4).
4) Fill   the funnel filter with ground coffee, without pressing it (Fig. 5).   Fill it a little at a time to prevent spilling the ground coffee.
5) Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter.
IMPORTANT: Use good quality, medium-ground coffee, for MOKA coffee makers.
6) Tighten   the coffee maker securely , without exaggerating, holding the boiler   with one hand and turning the pitcher clockwise with the other, without   pushing on the handle
7) Rest the coffee maker on the base ( Fig. 6) . Close the lid.        
8) Press the on/off switch (Fig. 7)        
9) The coffee will start to be released after a few minutes.        
10) When the pitcher is full, mix the coffee for uniformity before serving it .            IMPORTANT:   the first time that the coffee maker is used, all the accessories and   the internal circuits should be washed with hot water. Then make a few   batches of coffee to throw away.    

CLEANING AND MAINTENCE    . Before performing the cleaning operations, wait for the coffee maker to have cooled down after use.
. Clean the inside of the tube periodically.
. Regularly check the funnel and the gasket. Replace if there are signs of wear or deterioration. Use original spare parts only.
. Every so often check that the holes in the disk filter are not blocked; if necessary, clean using a pin (Fig. 8).
. Do not wash the coffee maker in the dishwasher.
.When   cleaning do not use solvents or abrasive detergents. Simply clean it   with a sponge, keeping attention not to wet the electrical parts.
Never rinse the boiler under the tap water andnever immerse it in water.